SP Tools

This 39 mm was released to help the technician remove and install 12 point axle nuts on 2007 and newer Tundra and Sequoia trucks / SUV’s. 

This unique tool allows the technician to hold the water pump pulley securely while removing the viscous fan clutch on BMW V-8 and Sprinter Vans. 

This tool has been upgraded with spring loaded "silver" legs that allow the technician to set leg position prior to installing on the harmonic damper pulley to aid in the removal of the harmonic damper pulleys found on many Chrysler, and G.M. engines. 

This 3 pin fan clutch wrench has been developed to work on the 2009 and later 5.7 liter Hemi Truck engine. With it’s long reinforced pins it firmly engages the hard to reach holes on the conical shaped water pump pulley. Used with 95210, removing the fa 

This unique tool is designed to aid the technician in removal of the fan clutch. It’s pin design mates to the holes in the drive pulley of the fan clutch so that the technician can loosed the fan clutch nut. Holding this pulley correctly is required in  

This socket and hex tool were developed to aid the technician in servicing the GM Duramax diesel trucks. SEE ALSO #69250 GM DURAMAX FLYWHEEL LOCK. 

This unique tool was designed to hold the flywheel stationary when removing or replacing the crankshaft bolt. SEE ALSO #69200 DURAMAX CRANKSHAFT AND FLYWHEEL KIT 

This unique tool was designed to remove and install lower ball joints on the car versus removing the steering knuckle and using a press. 

HONDA / ACURA BUSHING X-TRACTOR™. “REMOVAL AND INSTALLAITON TOOL” 

This unique tool was designed to aid in the removal of the front lower control arm compliance bushings both 65 mm and 74 mm sizes found on many Honda and Acura vehicles. 

This unique tool was designed to reach down through the engine compartment in areas not easily accessed with conventional tools. This tool has a specific “clock” angle of the 6 point 19 mm end with carefully calculated handle geometry enabling access to 

These unique tools were designed to remove the hub bearings that are rusted to the steering knuckle, without removing the steering knuckle from the vehicle or the CV axle assembly, also when utilized properly does not require the use of a press. 

This unique tool was designed to allow the technician to support the engine. Works on: 2006 and later IS250 2WD 2006 and later IS350 2WD 2006 GS 300 2WD 2007 and later GS350 2WD 

Manual Bushing R&R Tool allows the technician to service a wide range of bushings without removing components from the vehicle. 

“Used for bushings, wheel bearings* and ball joints” This Mobile Hydraulic Press Tool allows the technician to service a wide range of bushings, wheel bearings* and ball joints without removing components from the vehicle. 

This unique specialty tool has been designed to easily remove “ripped” and “stuck on” spark plug boots where there is no access to grab the boot for removal. 

Forged • 6 Point • Super Strong This unique tool has been designed to R&R "can" type shielded oxygen sensors and air fuel sensors currently found on later models vehicles. 

This wrench is designed with small diameter grooved pins to allow access to small hole cam gears. 

This unique tool allows the technician to access the tensioner from the top side of the engine. This saves the technician tremendous time as compared to the current method of accessing from the bottom of the engine. 

With this latest evolution to our Universal Valve Spring Tool we have added the ability to actuate the compression tube even in tight confined locations like under the cowl where the lever cannot be moved or may not even fit.