SP Tools

This unique tool has been developed to aid in the installation of balance and camshaft seals for most Honda and Acura engines. 

This tool allows the technician to accurately remove and install the shift linkage pin on vehicles using shift rod linkage. 

These unique tools were designed to remove the hub bearings that are rusted to the steering knuckle, without removing the steering knuckle from the vehicle or the CV axle assembly, also when utilized properly does not require the use of a press. 

This unique tool was designed to allow the technician to support the engine. Works on: 2006 and later IS250 2WD 2006 and later IS350 2WD 2006 GS 300 2WD 2007 and later GS350 2WD 

This specialty designed patent pending dual ended tool has small magnets that are designed to aid in the removal of hard to reach washers that are around most types of studs. 

Manual Bushing R&R Tool allows the technician to service a wide range of bushings without removing components from the vehicle. 

A special tool is needed to depress the valve spring for removal of the hydraulic valve lifters. 

This tool allows for the easy adjustment of the camshaft spur belts having idler pulleys with pin holes. 

“Used for bushings, wheel bearings* and ball joints” This Mobile Hydraulic Press Tool allows the technician to service a wide range of bushings, wheel bearings* and ball joints without removing components from the vehicle. 

This specialty wrench is for use on most 1970 and later model AMC, Ford, General Motors, Isuzu, Jeep, Nissan, Opel and Toyota automobiles with rear mounted Monroe replacement shock absorbers. 

These pliers have been developed to remove the valve stem seals which are used on most overhead camshaft engines. 

UNIVERSAL OHC VALVE SPRING COMPRESSOR Updates #91400 or similar kits that have a 5/8” bar 

OrganizeAIR™ Tired of misplacing or losing air tool attachments? 

“For Use With Any Size Electrical Connectors” These wrenches have been designed for use with most all oxygen sensors no matter what size electrical connectors they have. 

12 & 6 POINT OXYGEN SENSOR WRENCH WITH PIVOTING HANDLE 

This specialty socket has been designed to open and close most radiator drain plugs that have thumb wings. 

This unique tool has been developed for removal and installation of relay and fusible links on many later model automobiles. 

The tip of this tool has a precision machined cavity which holds the 1/4" roll pin due to a slight press fit. 

The tip of this tool has a precision machined cavity which holds the 1/8" roll pin due to a slight press fit. 

The tip of this tool has a precision machined cavity which holds the 3/16" roll pin due to a slight press fit.