This unique tool has been designed to R&R "can" type shielded oxygen sensors currently found on later models of Toyota and Lexus vehicles (excluding 2004 and later four cylinder engines) also 2007 and later Mazda's that have a heat 

This wrench has been designed for use with most all oxygen sensors no matter what size electrical connectors they have. 

12 & 6 POINT 2-1/8" offset OXYGEN SENSOR WRENCH works with many GM products found in Corvettes, Camaros and Firebird/Trans Am. 

This 39 mm was released to help the technician remove and install 12 point axle nuts on 2007 and newer Tundra and Sequoia trucks / SUV’s. 

HONDA / ACURA INTEGRA TRAILING ARM BUSHING X-TRACTOR™ UPDATE KIT For 65100 will do 1990-1993 INTEGRA 

"For Use On Most Constant Tension Type Hose Clamp"s 

Serpentine, Timing & V-Belt installation assist 

For use on Aluminum & Steel Heads 

These unique tools have been developed for use in disconnecting the fuel and air conditioning line couplers found on most late model automobiles. 

These unique tools have been developed for use in disconnecting the fuel and air conditioning line couplers found on most late model automobiles. 

These unique tools have been developed for use in disconnecting the fuel and air conditioning line couplers found on most late model automobiles. 

Part Number(s) #66110 66120 66130. These unique tool sets allows the technician to easily lift and maneuver cylinder heads when service is needed. 

This unique tool was designed to remove and install lower ball joints on the car versus removing the steering knuckle and using a press. 

HONDA / ACURA BUSHING X-TRACTOR™. “REMOVAL AND INSTALLAITON TOOL” 

Part Number #65100 has been upgraded to #65130 

This tool was developed to aid in the alignment of the clutch disc to the flywheel and cover. 

This unique tool was designed to aid in the removal of the front lower control arm compliance bushings both 65 mm and 74 mm sizes found on many Honda and Acura vehicles. 

This unique tool was designed to reach down through the engine compartment in areas not easily accessed with conventional tools. This tool has a specific “clock” angle of the 6 point 19 mm end with carefully calculated handle geometry enabling access to 

This unique 50mm tool has been developed to aid in the removal and installation of the crank bolt on most Honda and Acura engines. 

This tool allows the technician to accurately remove and install the shift linkage pin on vehicles using shift rod linkage.